Many of us use our biscuit joiner daily, others on a weekly or monthly basis, but , no matter your frequency of use, eventually, you will need to change its blade. A sharp blade maintains your joiner fast, effective and precise so when a person's power tools have these qualities, usually the crafter behind it does too. Fortunately for us craftmen, then, replacing the knife over a Porter Cable biscuit joiner is a relatively simple process. Despite a slightly more complicated nick deflector and lock pin number, changing your Porter Cable biscuit joiner blade requires a bit more than a few minutes, a screwdriver and an Allen wrench.
Since with all power tool repair procedures, the first step in changing your joiner blade is disengaging and unplugging the tool. Next, simply flip the tool over and loosen the screws in the bottom plate. Your Porter Cable biscuit joiner should have four screws and because this tool also features tapered screw holes, you will not need to completely remove the anchoring screws to remove the plate; instead you can simply slide the plate off (slide the plate towards the bottom of the tool and lift to remove). This, of course , gives you accessibility to the blade.
Wait around! Before grabbing at the 9 reviews blade, though, you must depress the lock flag. The lock pin on Porter Cable biscuit joiners is at the very best entrance of the tool (more-or-less) beneath the handle. Pressing this pin prevents the blade from spinning allowing users to safely remove it. The secret, though, is that the lock flag must be depressed constantly as you remove the blade and that the blade must be removed with an Allen wrench. So, while depressing the locking pin with your secondary hand, use your major hand to insert your Allen wrench into the centre of the blade bolt, loosen and remove it. Carefully remove the blade.
Directly beneath the blade, the Porter Cable biscuit joiner has an adjustable chip deflector. This mechanism allows the tool to accommodate both standard sized blades and smaller face-frame blades. Depending after the size of the new blade you've put on the joiner, you may now need to change the chip deflector. Regarding standard sized blades, this swiveling mechanism should stay in the horizontal (left - right) position (or, more-or-less parallel to the directional arrow stamped above it). If, however, you installed a smaller blade, you should have to pull the engine forward to release it and shift the nick deflector to a up and down position (so that it now points to the front of the tool and crisscrosses with this directional arrow).
Next, you must install the new joiner blade. The knife will have a similar directional arrow printed on the surface. This arrow is designed to ensure users install the cutting tool having its teeth facing the right direction. Install the blade so that the arrow points in the same direction as the directional arrow on the tool. Pop the knife into place and and replace the washer and bolt. While depressing the lock pin tighten the bolt over the knife.
After securing the cutting tool, you need only slide the bottom plate back into place and tighten down the four screws that keep it there. And that is exactly that. Give yourself a pat on the again and know that your Porter Cable biscuit joiner is now as good to go as you are.
Joining M&M Tool and Machinery and ToolsandMachinery. com in December of 06\, Mallory has refined the girl expertise in power tool components, tool repair and many more aspects of the woodworking and production industries. Her hands-on experience with woodworking machinery, power tools and strength tool parts ensure the girl knowledge is current, and her solid relationships with major factory representatives and M&M's own staff of experienced crafters and techs ensure her wit and info remain sharp. - Offering the most thorough inventory of power tools, replacement parts, machinery and accessories, ToolsandMachinery. com is the ultimate resource for your woodworking, crafting, DO IT YOURSELF, and construction needs.